Общие методы установки геотекстильной композитной геомембраны
As the key medium of the anti-seepage structure, the geomembrane layer should meet the stress requirements during installation, because the leak control effect of geomembrane is related to its strength and thickness. Therefore, choose the appropriate thickness according to the design stress.
The геотекстильная композитная геомембрана heated with geotextile on one side or two sides has the features of high overall strength, tear resistance, anti-breaking and anti-piercing ability. The geotextile compounded on the membrane surface has supported and protected abilities.
For the leak control structure utilized with composite geomembrane, in general, the support layer and the protection layer can be simplified. For example, this geotextile composite geomembrane can be directly laid before the placement of concrete facing surface or the protective surface composed of the gravel cushion and the concrete slab. After laying this composite geomembrane, the medium coarse sand cushion can be directly laid.
The phenomenon that geotextile composite geomembrane is punctured is caused by the unenven subgrade, so it is important to prepare and maintain the civil works of subgrade.
General geotextile composite Геомембрана installation method:
Во-первых, обработка земляного полотна
Subgrade should be prepared according to the design requirements, which is the key to ensuring the leak control performance. The substances including sharp stones, roots and other foreign subjects should be thoroughly removed, and subgrade is not allowed to be uneven. The prepared and maitained subgrade should be compacted by a tamper or a seesaw.
Во-вторых, укладка
При укладке геотекстильной композитной геомембраны ее необходимо укладывать сверху вниз. Перекрытие между геокомпозитами, а также между геомембраной и земляным полотном должно быть ровным и плотным, но оно не должно быть натянуто слишком туго, как правило, оно должно быть слегка рыхлым. Пузырьки должны быть не допущены на дне. Поскольку геотекстильная композитная геомембрана относительно тонкая и легкая, ее легко сдуть ветром до того, как будет уложен защитный слой. Поэтому геотекстильную композитную геомембрану не следует развертывать с большой площадью за один раз. Уложите защитный слой грунта после того, как геокомпозит будет хорошо уложен.
В-третьих, совместные
The joint has three methods of hot-melt welding, gluing and compacting, wherein the hot-melt welding has the best waterproof effect.
Шанхай Инфань Энвайронмент Инжиниринг Лтд.